Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Default Routing based on Source Adress

Hi to all

our loadbalancer is attached to a firewall with multiple interfaces. I configured policy based routing on the loadbalancer so that based on the source Ip Adress the Loadbalancer chooses the right interface on the firewall. This configuration worked fine until the firewall changed is natting interface from eg 194.41.160.2 to 194.41.160.1. The address 194.41.160.1 is configured on the loadbalancer as a service adress type tranparent-cache. When the request comes to the loadbalancer then the loadbalancer doesn't route this packet.

Any Suggestions ?

In the attachement I posted the configuration.

1 REPLY
Silver

Re: Default Routing based on Source Adress

Specifies the service is a transparent cache. No rules are applied to requests from the cache. Ensure interfaces are specified for entries in the cahe.

105
Views
0
Helpful
1
Replies