Sure, you can still use the config I gave you and modify it a bit. You can put each server in its own serverfarm. Then you can load balance to its own serverfarm based on the source-ip address. With the example I provided, i'm using source-ip to do source NAT. In your case you would use source-ip to do NAT and to load balance to the serverfarm that the server resides.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...