Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

diable routing of management port.

I have not been able to find a way to not introduce the management ports IP/network in the routing table when using the newer CSS code. Is it possible to revert back to the behavior of prior releases of Webns?

Thanks!

2 REPLIES
Cisco Employee

Re: diable routing of management port.

it shows in the routing table but there should be no routing between a normal port and the management port.

There is no way to prevent it to show up in the routing table.

Gilles.

Community Member

Re: diable routing of management port.

Thanks.

With it in the routing table, it seems to prevent traffic from taking the correct path, which was via a different interface.

For example, I have a 192.168.252.0/24 network assigned to the management port. I also have some devices in that network I would like to route through the CSS to reach. This no longer works since my former static route for 192.168.252.0/24 is gone and replaced by the management port route.

110
Views
0
Helpful
2
Replies
CreatePlease to create content