Hi, been studying and deploying FWSM for a while and now starting to do the same with ACE. After studying the capabilities, I'm starting to wonder the difference between ACE and FWSM. I know that ACE has much more features than FWSM (loadbalancing etc) But it also can do the same things that FWSM can do. What can the FWSM do, that ACE can't do ??
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...
Introduction This document will run you through a step by step
configuration example of Inter VRF route leaking in Cisco Application
Centric Infrastructure(ACI). This article describes the steps with
screen shots of example configuration and some verifica...