06-12-2012 06:23 AM
Hi All,
We are running the ACE blade (A2.3.4) adn have the following configuration.
A serverfarm configured:
serverfarm host SF-GRG-Logger-7300
failaction purge
probe GRG-Logger-7300
rserver GRG-LOGSRV-01 7300
backup-rserver GRG-LOGSRV-02 7300
inservice
rserver GRG-LOGSRV-02 7300
inservice standby
When the active server goes down it purges the connections as it should and the standby becomes operational.
The issue we have is when the primary comes back into operation and the active goes back to standby it leaves the connections to the server as active.
Is there anyway to clear these connections?
Thanks in Advance.
Jack.
Solved! Go to Solution.
06-13-2012 01:18 AM
06-12-2012 11:54 PM
Hi Jack,
What you are describing is the expected behavior. The connections that were already stablished to the stanby server will continue on it to avoid impacting the clients. New connections, however, will be sent to the primary server as usual
If you want to manually clear them, you can use the command "ACE# clear conn rserver
Regards
Daniel
06-13-2012 12:53 AM
Hi Daniel,
Thanks for your reply.
What I wanted to know is if there was any mechanism to automatically clear these connections once the primary device became active again and the secondary was standby?
Regards.
Jack.
06-13-2012 01:18 AM
Hi Jack,
No. As I said, this behavior is by design.
Regards
Daniel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: