Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FLOWMGR-3: GroupComm should not deliver an FmPeer message to the sender!

Hi,

First : We have two Content switches in active backup setup

Version: sg0750103 (07.50.1.03)

Flash (Locked): 07.50.1.03

Flash (Operational): 07.50.1.03

Type: PRIMARY

Licensed Cmd Set(s): Standard Feature Set

The above error occurs on the master switch. Ip addresses and vip's stay alive. %Master remains master but doesnt seem to handle the backend flows.

In the logs I see alot of the following messages when the problems occur :

DEC 10 20:55:56 1/1 3160 FLOWMGR-3: GroupComm should not deliver an FmPeer message to the sender!

Does anybody know what this message refers to ?

Any help would be appreciated.

Kind regards,

Ronny

1 REPLY
Cisco Employee

Re: FLOWMGR-3: GroupComm should not deliver an FmPeer message to

this is actually a bad message.

The groupcomm process sees its own message in its queue. This should not happen.

I would recommend an upgrade to 8.20 and if the problem persist open a service request with the TAC.

Provide 2 'show tech' captured at 1 minute interval when the problem is there.

Thanks,

Gilles.

203
Views
0
Helpful
1
Replies