group-list Indicates to the router which Content Engine IP addresses to allow packets from.
redirect-list Sets the access list used to enable redirection.
With the redirect-list you can configure access-lists on the router to deny or allow certain ip addresses to use WCCP redirection to the CE. Don't forget that there is an implicit 'deny all' in the access list. So if you use an access list to deny certain ranges, don't forget to have last statement 'access-list ip any any'.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...