I have a very simple SLB configuration on my 6509 switch running IOS. I tried moving the configuration from IOS to the CSM Module. I did this by simply removing the ip slb commands and writing the same configuration under module CSM #. Once the config was done I saved it, but it did not work. I have only this one CSM in the switch; is there something else I need to do? Do I have to change from RP mode to CSM mode?
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...