Hi there...we have an ftp service that uses the ftps protocol (port 990 I believe) and I can't seem to get it to work behind the CSS....I get to the authentication but the data channel is not making it through...
I also think that port redirection may be causing some issues as well..
My content rule is listening on port 990, and the service rule is using port 6855 (see below for config snippets)
ip address 188.8.131.52
keepalive port 6855
vip address 184.108.40.206
add service blahblah:6855
Any thoughts, suggestions, or advice would be greatly appreciated.
Thanks in advance!
These forums are the most useful learning and troubleshooting tool I have ever used! Keep up the good work...
Moquery is the command line cousin of Vizore, it's very helpful and efficient sometimes during the troubleshooting. This article aims to provide moquery cheat sheet to the users for some most common seen scenarios.
Here is the checklist before customers/partners contact Cisco TAC:
Firmware Version of APIC and Switch
Download Switch and APIC techsupport logs
Problem description (Symptoms with details)
Business impact (eg, what kind of services...
moquery usageAPIC moquerySwitchmoquery
This document discuss a common issue observed during the VMM integration & VM workload migration to ACI fabric.
VMware Virtual machines are hosted in Cisco UCS-B seri...