I had to change the IP address of my primary GSS and now the secondary GSS shows up as pending under the resource tab of the HTTPS GUI. I stopped the service and changed the IP and DFGW and started the service and rebooted the PRI. I then stopped and restarted the GSS service on the secondary. The devices can ping each other and are located on the outside of the FW.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...