I designing a waas solution and ace interception and i found some issues i attached simple topology for the network it has 150 branch and we will implement waas in 6 branches as start the topology has 2 6500 each with 1 ACE moduel .
1.as start i know that i shoul make 3 vlans one for server & 1 for WAEs and 1 for client i don't have problme in servers or WAEs my issue is branches connected to 6500 directly via serial so i can't make vlan for client to apply load balance service policy on it i need to apply it to serial interfaces directly
can i do that with ACE for example in case of client Vlan i was assign vlan to ACE do i need same thing for serial interfaces?
2.should i configure default gateway for core WAE on interface vlan500 of 6500(which contain WAEs).
3.I didn't configure fallover 2 ACEs that mean sepearet vlan for right WAes and one for left so will that cause any problme note that some branchs connected to each other i'm talking about asymitric routing.
i was thinking in simple solution to apply load balancing policy in traffic passing through serial interfaces so if i create 3 vlans and assign to ace 1for WAEs & 1 for data center and one for traffic of wan
now i need to enforce traffic come from serial interfaces to pass vlan of wan
i'll cofigure route map to inforce traffic come from remote branches to go wan VLAN and then apply load blancing policy
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...