Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Help with config for Active-Backup VIP and Virtual Interface Redundancy

I am in the process of configuring a second CSS for failover. I want to have servers in two different locations that are attached to a layer 2 switch and then connect to the content switches. I also want all servers to continue working when one of the CSSs fails. I need to know how to configure the 2nd CSS to make this work. Any help would be appreciated.

The network flow is as follows. Internet>Firewall>layer2 switch>CSS>layer2 switch>servers

3 REPLIES
Bronze

Re: Help with config for Active-Backup VIP and Virtual Interface

Cisco Employee

Re: Help with config for Active-Backup VIP and Virtual Interface

what you need is ASR [adaptive session redundancy].

Here is a link to the configuration guide:

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a00801ef2a1.html

This is only available with CSS 2nd generation and version 7.x or 8.x

Gilles.

Cisco Employee

Re: Help with config for Active-Backup VIP and Virtual Interface

what you need is ASR [adaptive session redundancy].

Here is a link to the configuration guide:

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a00801ef2a1.html

This is only available with CSS 2nd generation and version 7.x or 8.x

Gilles.

144
Views
0
Helpful
3
Replies
CreatePlease to create content