Regarding setting up the ArrowPoint with Virtual IP Address (group command) for the 2 HA Machines: When the 2 HA Servers try to connect to a Port on an external Server, will the return traffic know how to route to the correct HA Server ?
Will it possible for the return traffic be routed to the wrongserver because of the load balancing and source IP being the same.
We have seveal connections between both HA servers and other server at the same time. If the source/destination IP and the destination port are the same, there is a chance when source port can be the same. So what will happen?
The group command changes the source port of the internal server initiating the connection. It creates a portmap table for the original source port. For more information on source groups and the base ports it uses see the advanced config guide:
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...