Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How Do I configure between Cisco ACE Modules for fail-over in a single 6509?

Hello, Sir/Madam,

I have seen a good document for fail-over redundancy of ACE modules.

the url is http://www.cisco.com/en/US/partner/docs/app_ntwk_services/data_center_app_services/ace_appliances/vA3_1_0/configuration/admin/guide/redundcy.html

Now, I know that how Stateful failover is supported across two Cisco Catalyst 6500 Series chassis.

But I do not know how Stateful failover is supported within a Cisco Catalyst 6500 Series chassis.

May I have your suggestions for this question? (configurations)

I guess I can configure the same way that mentioned above url in another ACE appliance even though those are within a single Chassis.

Am I right?

Thanks a lot in advanced.

Regards,

Lim

  • Application Networking
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How Do I configure between Cisco ACE Modules for fail-over i

Hi Seok-Bin,

HA is supported also within the same Cat6k.

As you correctly said, the configuration is exactly the same, so feel free to follow the one from the URL you mentioned.

Cheers,

Domenico.

2 REPLIES
Cisco Employee

Re: How Do I configure between Cisco ACE Modules for fail-over i

Hi Seok-Bin,

HA is supported also within the same Cat6k.

As you correctly said, the configuration is exactly the same, so feel free to follow the one from the URL you mentioned.

Cheers,

Domenico.

New Member

Re: How Do I configure between Cisco ACE Modules for fail-over i

Thanks a lot,

I feel free now,

229
Views
0
Helpful
2
Replies
This widget could not be displayed.