In offdm mode, I tried to set my content switch 111150 to boot from network. I always failed. Could you please tell me how? I got quite confused with the kernel path and config path. Are they the paths I set on FTP server or are they different? Thanks.
Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
Thank you, but I think the first document should be amended to avoid misleading. I would like to suggest adding preassumption of FTP configuration. I configured my ftp server with root directory of d:/cisco. When I enter FTP kernel path as /cisco/hdd, the CCS never boot from my ftp server. For your reference only. Thanks again.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...