Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to configure 2 CSM modules in 6500 ?

hi,

6500 supports multiple CSM modules in one chassis. I check the configuation about the CSM with 2 modes one is rp and another is csm. another mether is to enter the csm module. Does anyone know the current way to setup the 2 csm modules in one 6500 or give me a sample ?

best regards.

fred.

3 REPLIES
Community Member

Re: How to configure 2 CSM modules in 6500 ?

If you are running muliple CSM's in the same chassis you need to run in csm mode, otherwise if you are running a single csm in a chassis you can run in rp mode.

hope that helps

I am running one csm in each chassis and fault-tolerant

mark

Community Member

Re: How to configure 2 CSM modules in 6500 ?

hi,

I can't see any configure about the second CSM in CSM mode.

This is my problem.

best regards.

fred.

Cisco Employee

Re: How to configure 2 CSM modules in 6500 ?

what do you mean you don't see the config ?

You should create it after entering the following 'mod csm '

I have 2 in the same catalyst and I can see the config for both.

Gilles.

125
Views
0
Helpful
3
Replies
CreatePlease to create content