Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

how to configure css with two redudant L2 switches

Question:

if i have one CSS to connect to a redundant datacenter(two routers and two core switches), how do i configure it so that the css provides service to both networks ?

regards

PT

3 REPLIES
New Member

Re: how to configure css with two redudant L2 switches

I believe this is a simple spantree issue, if both ports on your content switch are bridged to the same vlan, then spantree will decide which port to use.

You won't be able switch content on both l2 switcches at the same time.

Jonathan Nantel

awo
New Member

Re: how to configure css with two redudant L2 switches

Could you explain this behavior ?

New Member

Re: how to configure css with two redudant L2 switches

How would this change if the scenario was 2 CSS boxes each plugged into a seperate L2 switch, but the same VLAN and with the L2 switches being connected to each other and the CSS boxes connected together via crossover for redundancy?

166
Views
0
Helpful
3
Replies
CreatePlease to create content