02-03-2010 01:16 AM
Hello,
From CSS11501 show log-state all subsystem in debug-7 log level,
I would like to configure it to default,
So I configure it in globle mode as below,
CSS11501(config)#logging subsystem all level warning-4
show log-state, it's show the level are all warning-4 state,
but after reboot system, the log-state still back to debug-7 level.
How to reset the CSS11501 logging state to default ?
Thank,
HS
02-03-2010 05:37 AM
The log level has been set in offdm for your CSS.
You need to boot into offdm and change the logging level there.
From the CSS prompt type "reboot".
When you see the line "do you want ..." press "Y".
Once in offdm, press "
Then press "1" to enter configuration mode
Then "3" for Set logging flags
Then "2" Set Logging level.
Regards,
Gilles.
02-03-2010 05:41 AM
Hello HS,
If your running-config shows all logging at 4, but you are still seeing higher level logs in the sys.log file, then you might need to check your offline diagnositcs log settings and set them to 4 there.
Setting Logging Level in Offline Diagnositcs
Hope that helps,
Sean
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide