We are using CSM-S in one-arm design. The problem we are facing now is that the CSM as well as the SSL proxy does not allow us to use the same address for CLIENT-SSL traffic stream and SSL-SERVER stream.
For exampe if I try to do it in the SSL Proxy it gives me the following error:
Error: Server IP address is in use by some other STE component
That means for each secure application we will end up using 2 ip addresses which is a bit of waste. I am wondering if there is a solution to this situation.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...