I would like to seek some advice on the redirection feature (using service type redirect) in a one arm CSS configuration.
In our environment, we process incoming HTTPS request and load balance to 2 HTTPS Servers. In the event that all the local services are unavailable, the request will be forwarded to a webpage located in either a HTTP or HTTPS Server.
Below is a sample config. However, it doesnt redirect when the local services become unavailable.
Instead, i change the whole config such that it process incoming HTTP request (not HTTPS), load balance to 2 HTTP servers and redirect to a HTTP server when local service fails. This time it works.
Do the redirect service type only works with incoming HTTP request only and not with incoming HTTPs request?
Is it able to redirect for the following senario?
1) incoming HTTPS, redirect to HTTPS Server or HTTP Server when local service are unavailable.
2) incoming HTTP, redirect to HTTP (tested it works) or HTTPS server.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...