I see the last disconnect err: "Received invalid status code" which means that ACE is not getting what is expected (code 200) for it to mark the server as passed.
Also, i see you have configured url "request method head url //ssdsd/servlet/SDLogin", why are you using two slashes "//", can you try with only one?
Also, if you configure probe on TCP PORT 443 does it pass? I see last disconnect err: connection reset by server as well and that could be due to the fact that service was there on server. Looks unlikely since above probes failed due to wrong status code which means that SSL handshake happened.
You can take a pcap on server as well as ACE to see what is going on. You might need to use private key to decrypt the captures if the failure is after SSL handshake has completed to see what status code server is sending. You can also use TCP 443 based probe as workaround till you can arrange pcaps and figure out what is wrong.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...