I have the Inband Health Monitoring in my CSM with sw 4.2(2)
health retries count failed seconds
and I see that the csm declare failed the server only if see the Reset. I'd like to know if there is the possibility to have the server failed still I don't see the syn ack, without using probe but only with Inband Health Monitoring.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...