Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

inband management on Nx 7010 without M1 card

Hello,

For a distrib layer, I would want to create an inband management (in case of we are a issue on OOB mgmt, i means to have a 2960 HS) on Nx7010 chassis without M1 card (only F1 cards - layer 2). I could create a interfce vlan but the status of the interface is down/down.

I have an other 2 x Nx7010 pair with M1 card ; for this pair, i can connect the interface ; the inband interfaces is up/up

I have also 2 x Nx5596 pair  ; for these boxes, i can connect the interface ; the inband interfaces is up/up

Do you know a solution to get 1 interface vlan up/up on chassis 7010 without M1 card in order to have an inband connexion ?

many thanks for you assistance.

Nicolas.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

inband management on Nx 7010 without M1 card

Hi Nicolas,

Yes that is possible. You need to use management keyword on that L3 VLAN on F1 card. More info here:

http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_layer3int.html#wp1611397

Nik

2 REPLIES
Cisco Employee

inband management on Nx 7010 without M1 card

Hi Nicolas,

Yes that is possible. You need to use management keyword on that L3 VLAN on F1 card. More info here:

http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_layer3int.html#wp1611397

Nik

New Member

inband management on Nx 7010 without M1 card

Hi Nik,

Thank a lot for this right answer + the URL.

Have a good day

Nicolas.

549
Views
0
Helpful
2
Replies
CreatePlease to create content