Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Inline card connectivity

Original LAN switch GE port configured 100/full and connected to router FE port (100/full) directly.

Now we are setting WAE 612 in between both devices and configured InlineGroup 1/0 to 100/full, but the router FE IP cannot be ping this moment.

When I remove 100/full settings from WAE InlineGroup 1/0, then the IP of router FE port can be ping to. But WAE InlineGroup (LAN and WAN) are showing 100/half.

Is it affected by the cable issue? Not using crossover cable to plug into Router FE port and WAE InlineGroup (WAN port).

1 REPLY
Cisco Employee

Re: Inline card connectivity

For 100/full connectivity, you need to use a crossover cable for one of your cables. Please refer to the following cabling guide for specifics.

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/wae/module/inline/installation/guide/17880fru.html#wp40063

Thanks,

Dan

126
Views
10
Helpful
1
Replies