Is there a way to track Admin usage of ANM (application network manager)? We have a few servers running the ANM application. Each ANM server points to/manages ACE blades (in the datacenter where the server resides). I would like to understand how much the ANM gui is used for each of the servers. I have looked through the GUI for some sort of report but wasn't able to find one. Cisco ACS has the "Adminstration Audit" report which shows all admin activity of the application per admin user (per ACS server). Is there an equivalent report for ANM?
In addtion I would like to know how much of the ACE config activity is spawned via CLI versus the ANM gui.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...