How do we configure a "tag" value under a content rule to enable it to respond to the GSS initiated queries.
On the GSS I just configured a "KAL-VIP by tag". This is a shared keepalive against a CSS circuit address. I give a tag a value here. I need to match this tag value on the CSS CRule as well as per the CCO online. How do I do it. Any help much appreciated.
Following is from the GSS Help document.
The VIP-type answer KAL-AP keepalive sends a detailed query to the Cisco CSS or CSM to extract load and availability. Online status is determined when these SLBs respond with information about a hosted domain name, host VIP address, or a configured tag on a content rule.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...