I have a need to limit access to a certain VIP to a couple of subnets. I am assuming I would have to create multiple class maps and nest them. But I cant seem to find the right configs to get it working.
Can someone send me a link or a simple config that would allow me to do this.
BTW, I have seen a couple configs on cisco.com recommending a way. Its just that my ACE module does seem to support that configuration. (Or maybe I am confused ... :-])
I am running A2 (1.0)
Thanks in advanced for your help,
=============== show ver output=================
ACE/Admin# sh ver Cisco Application Control Software (ACSW) TAC support: http://www.cisco.com/tac Copyright (c) 2002-2008, Cisco Systems, Inc. All rights reserved. The copyrights to certain works contained herein are owned by other third parties and are used and distributed under license. Some parts of this software are covered under the GNU Public License. A copy of the license is available at http://www.gnu.org/licenses/gpl.html.
Software loader: Version 12.2 system: Version A2(1.0) [build 3.0(0)A2(1.0) adbuild_16:29:03-2008/03/04_/a uto/adbu-rel3/rel_a2_1_throttle/A2_1/REL_3_0_0_A2_1_0] system image file: [LCP] disk0:c6ace-t1k9-mz.A2_1.bin installed license: no feature license is installed
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...