Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load Balance LNS

Hi,

Has anyone configured CSM (Content Switching Module) on Catalyst 6513 to load balance LNS (L2TP Tunnel Server) as described in Figure-6 from http://www.cisco.com/en/US/netsol/ns341/ns396/ns301/ns242/networking_solutions_white_paper09186a0080108939.shtml ? My Catalyst 6513s are running Native IOS 12.1(11b)E4 and CSMs are running software 2.2(2a). I have tested successfully for telnet service but not for L2TP (UDP 1701).

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Load Balance LNS

That should be fine, as long as the vserver is set for UDP and the proper port. That version of CSM code is not very recent. Version 2.2(8) may be better. I would not upgrade unless you hit a specific bug, unless you are just putting this into QA or other test environment. Upgrading is always harder after it goes live.

UDP support started in version 2.1 so you may be fine either way.

2 REPLIES
New Member

Re: Load Balance LNS

That should be fine, as long as the vserver is set for UDP and the proper port. That version of CSM code is not very recent. Version 2.2(8) may be better. I would not upgrade unless you hit a specific bug, unless you are just putting this into QA or other test environment. Upgrading is always harder after it goes live.

UDP support started in version 2.1 so you may be fine either way.

New Member

Re: Load Balance LNS

Thanks for your suggestion. I have solved this problem by upgrading CSM software to 2.2(6).

119
Views
0
Helpful
2
Replies
CreatePlease login to create content