Re: Load Balanced server can not browse to Virtual IP
this is the typical problem.
When going from server to vip, the problem is that the receiving server, will see the request coming from a device on a locally attached network and it will send the response to the server/client directly without going through the CSS.
Therefore, the client receives a response from an unknown device since the CSS could not nat the response back to the vip address.
The only solution is to nat the server_client ip when it connects to the vip so it forces the server to respond back to the css.
If you don't want to have to nat all your traffic you need to use an acl to do this.
clause 10 permit any x.x.x.x destination content
clause 99 permit any any dest any
Replace x.x.x.x with a server ip.
Create a similar clause for each server.
The vip in the group can be the same as the content rule vip or any other ip address that will belong to the CSS.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...