Re: Load Balanced server can not browse to Virtual IP
this is the typical problem.
When going from server to vip, the problem is that the receiving server, will see the request coming from a device on a locally attached network and it will send the response to the server/client directly without going through the CSS.
Therefore, the client receives a response from an unknown device since the CSS could not nat the response back to the vip address.
The only solution is to nat the server_client ip when it connects to the vip so it forces the server to respond back to the css.
If you don't want to have to nat all your traffic you need to use an acl to do this.
clause 10 permit any x.x.x.x destination content
clause 99 permit any any dest any
Replace x.x.x.x with a server ip.
Create a similar clause for each server.
The vip in the group can be the same as the content rule vip or any other ip address that will belong to the CSS.
Moquery is the command line cousin of Vizore, it's very helpful and efficient sometimes during the troubleshooting. This article aims to provide moquery cheat sheet to the users for some most common seen scenarios.
Here is the checklist before customers/partners contact Cisco TAC:
Firmware Version of APIC and Switch
Download Switch and APIC techsupport logs
Problem description (Symptoms with details)
Business impact (eg, what kind of services...
moquery usageAPIC moquerySwitchmoquery
This document discuss a common issue observed during the VMM integration & VM workload migration to ACI fabric.
VMware Virtual machines are hosted in Cisco UCS-B seri...