Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Loadbalancing ldaps on ACE module

Is it possible to configure loadbalancing of ldaps with end-to-end mode (encryption from end to end) on ACE module ?

And if yes, do i have to use a special script for health checking ?

3 REPLIES
Silver

Re: Loadbalancing ldaps on ACE module

I have not come across Lodabalacing of LDAPs on ACE module. But it is planned to be suppored in future.

New Member

Re: Loadbalancing ldaps on ACE module

But what about ldaps termination (ldaps between clients and the ACE and in clear between ACE and servers)on the ACE box, is it supported ?

New Member

Re: Loadbalancing ldaps on ACE module

Please correct me if this is wrong or bad design: I have ldaps running just by permitting the port in the ACLs and VIP class. Customer says it works fine.

I'm sure you're aware of the health probe scripts you can get from Cisco (attached). This script defaults to ldap port (386) if none is specified. So you can specify the port under the "probe scripted LDAP_PROBE" config to use ldaps (636). Perhaps you should use both scripted probes together so that if one port is unavailable the server will be taken out of service.

383
Views
0
Helpful
3
Replies