Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Local Director doesn´t detect a failed server

I know this question has been asked before, but I still didn't find an answer

I have 1 virtual and 2 real web servers - one is backup (running linux/apache for the time being, but is supposed to be 2 Lotus Notes servers on AS/400). When I stop the web service on one server, it fails - that's okay. When I cut the power to simulate a hardware failure the server still is In-service and never goes OOS.

I don't know if the probe config is right, but I does not seem to have any effect.

Here is my config:

ip address 172.29.17.129 255.255.255.0

arp timeout 30

no rip passive

rip version 1

failover ip address 0.0.0.0

no failover

failover hellotime 30

snmp-server enable traps

snmp-server community public

no snmp-server contact

no snmp-server location

virtual 172.29.17.131:0:0:tcp is

real 172.29.17.139:0:0:tcp is

real 172.29.17.136:0:0:tcp is

backup 172.29.17.136:0:0:tcp 172.29.17.139:0:0:tcp

name 172.29.17.139 RHNTNWEB03C

name 172.29.17.136 RHNTNWEB03

bind 172.29.17.131:0:0:tcp 172.29.17.136:0:0:tcp

threshold 172.29.17.136:0:0:tcp 1

probe real 172.29.17.136:0:0:tcp http 1

probeconfig http 3

Thx for your help

2 REPLIES
New Member

Re: Local Director doesn´t detect a failed server

I am not sure if you are referring to this thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.ee88d6c

If so then i guess the problem could be solved by upgrading the LD to the latest version.

New Member

Re: Local Director doesn´t detect a failed server

The LD is up to date with version 4.2.4, so that should not be a problem.

135
Views
0
Helpful
2
Replies