Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Local Director & HTTP Redirection

Hi, just wondering if anyone has successfully implemented HTTP

redirection on Cisco Local Director 416 running ver 4.1.2 Basically I'm

after any pitfalls to look out for. Current implementation utilizes

generic session stickiness however this has problems for clients

trying to access our load balanced servers if they come from behind

multiple proxies via their ISP.

Servers are Private IP addressed (Firewall in front of LD performing NAT static

txlation)

On another point, how does the Cisco CS11000 (Arrowpoint) perform

session persistance/stickiness or what "better" ways does the

Arrowpoint acheive this as compared to Local Director?

Any helpful input would be much appreciated.

Rgds

Adam

1 REPLY

Re: Local Director & HTTP Redirection

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

174
Views
0
Helpful
1
Replies
CreatePlease to create content