Hi Guillermo! If I understand your question correctly you would like to loadbalance random ports to a set of servers. If this is a correct assumption, you can use port 0 (default) on the Virtual and the real servers to accomplish this as port 0 is a wildcard and will accept ports. I hope this helps out! Let me know if I misunderstood your question. -JB
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...