Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LocalDirector - SNMP

Is there any way to pull connection information (either virtual or real) for the servers on a LocalDirector? Right now I have to telnet into the LD and type 'show real' I would like to have something go in and track the number of connections over time by using something such as MRTG.

Any ideas?

  • Application Networking
1 REPLY
New Member

Re: LocalDirector - SNMP

Go to the LD beta download site at http://www.cisco.com/kobayashi/sw-center/internet/ld-beta.shtml register, and look for "CISCO-LOCAL-DIRECTOR-MIB.my"

Note that the Hosting Solutions Engine, and previous monitoring products, Content Flow Monitor and Localdirector User Interface, both used SNMP to get the real and virtual information. There were a few bugs in recent code releases that prohibited getting the virtual addresses and connections.

The older version of the MIB file is available from http://www.cisco.com/cgi-bin/tablebuild.pl/localdir

Also, check out the new 1105 at http://www.cisco.com/univercd/cc/td/doc/pcat/1105.htm It might be a good fit for your application.

130
Views
0
Helpful
1
Replies
This widget could not be displayed.