Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Logging buffered not working

Hello:

In an ACE  module multicontext environment the buffered logging is not working on the last context I created.

The same config though works well for another context.

The maximum size and the buffer size is showing 0 in the "show logging" below:

Thanks for helping

logging enable

logging standby

logging timestamp

logging trap 5

logging history 4

logging buffered 5

logging facility 16

logging queue 200

logging device-id context-name

logging host 10.10.10.1 udp/514

logging host 10.10.10.2 udp/514

logging rate-limit 42 60 level 0

logging rate-limit 42 60 level 1

logging rate-limit 42 60 level 2

logging rate-limit 42 60 level 3

logging rate-limit 42 60 level 4

logging rate-limit 42 60 level 5

logging rate-limit 42 60 level 6

logging rate-limit 42 60 level 7

##################################################

show logging`

Syslog logging:                 enabled

Facility:                       16

History logging:                enabled (level- warnings)

Supervisor logging:             disabled

Trap logging:                   enabled (level - notifications)

Timestamp logging:              enabled

Fastpath logging:               disabled

Persist logging:                disabled

Standby logging:                enabled

Rate-limit logging:             (min - 10000 max 100000 msgs/sec)

                42 messages 60 seconds level 0

                42 messages 60 seconds level 1

                42 messages 60 seconds level 2

                42 messages 60 seconds level 3

                42 messages 60 seconds level 4

                42 messages 60 seconds level 5

                42 messages 60 seconds level 6

                42 messages 60 seconds level 7

Console logging:                disabled

Monitor logging:                disabled

        Logging to 10.10.10.1 udp/514 

        Logging to 10.10.10.2 udp/514 

Device ID:                      context name "CTC_PROD7"

Message logging:                none

Buffered logging:               enabled (level - notifications) maximum size 0--------------------------->>>>>>

Buffer info: current size - 0 global pool - 4194304 used pool - 4194304

                min - 418816 max - 0

                cur ptr = 0 wrapped - yes

1 ACCEPTED SOLUTION

Accepted Solutions

Logging buffered not working

Hi,

This is because your global pool is full. Go to one of your other contexts clear logg , and will work.

Buffer info: current size - 0 global pool - 4194304 used pool - 4194304

Dan

2 REPLIES

Logging buffered not working

Hi,

This is because your global pool is full. Go to one of your other contexts clear logg , and will work.

Buffer info: current size - 0 global pool - 4194304 used pool - 4194304

Dan

New Member

Logging buffered not working

Thank you. I will try that.

495
Views
0
Helpful
2
Replies