Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MAC address table on CSS

How do I see the mac addresses on a CSS 11000 series switch?

7 REPLIES
Bronze

Re: MAC address table on CSS

What about "show arp"? Is this what you are looking for?

New Member

Re: MAC address table on CSS

I tried that, but it only shows the ip addresses, not MAC's.

Bronze

Re: MAC address table on CSS

On my 11506 it shows also the learned MAC's on the ports. Software Revision is 7.50 i think. Or are you looking for the MAC's of the Ports themselves like "show interface xyz" on IOS? Anyway gotta check again @ work tomrrow or Gilles might help you.

New Member

Re: MAC address table on CSS

I was looking for the mac's of the devices, not the ports themselves. We are only running 6.10, so maybe its not supported in that release.

Cisco Employee

Re: MAC address table on CSS

go into debug mode with the command 'llama'.

There type 'ip if' and you should get the interface mac.

gduf-css11000-1(debug)# ip if

SCM Interface table:

192.168.30.102/24 1021 ENABLED BROADCAST ARP

IF block at 0x836d4d00 SFP 128

Logical Ports: 0x00401f00

MAC: 00105800603b

1 interfaces using 140 bytes of memory

Gilles.

New Member

Re: MAC address table on CSS

That worked! Thank you.

New Member

MAC address table on CSS

Try using "show bridge forwarding"

best regards...!!!

982
Views
0
Helpful
7
Replies