05-17-2006 06:22 AM
How do I see the mac addresses on a CSS 11000 series switch?
05-17-2006 07:20 AM
What about "show arp"? Is this what you are looking for?
05-17-2006 08:04 AM
I tried that, but it only shows the ip addresses, not MAC's.
05-17-2006 09:25 AM
On my 11506 it shows also the learned MAC's on the ports. Software Revision is 7.50 i think. Or are you looking for the MAC's of the Ports themselves like "show interface xyz" on IOS? Anyway gotta check again @ work tomrrow or Gilles might help you.
05-17-2006 09:58 AM
I was looking for the mac's of the devices, not the ports themselves. We are only running 6.10, so maybe its not supported in that release.
05-17-2006 11:16 PM
go into debug mode with the command 'llama'.
There type 'ip if' and you should get the interface mac.
gduf-css11000-1(debug)# ip if
SCM Interface table:
192.168.30.102/24 1021 ENABLED BROADCAST ARP
IF block at 0x836d4d00 SFP 128
Logical Ports: 0x00401f00
MAC: 00105800603b
1 interfaces using 140 bytes of memory
Gilles.
05-18-2006 05:43 AM
That worked! Thank you.
10-03-2013 12:08 PM
Try using "show bridge forwarding"
best regards...!!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide