Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

map inbound tcp port 44444 to port 443?

I have a problem with a customer who authenticates all of his outbound http and https traffic on a proxy. I need for our software to connect outbound from his network on tcp port 44444, and then map that tcp port to 443 on my network before is hits my servers. I have a PIX and a CSS 11051. I have not had any luck with either. Any suggestions?

2 REPLIES
Cisco Employee

Re: map inbound tcp port 44444 to port 443?

when using a proxy, you open a tcp port to the proxy address and you pass in the info about the destination - port 443.

So, normally, the proxy should connect to your server on port 443.

If not, check what is going on with a sniffer trace.

If all you have to is nat, this can be done on the CSS.

Just specify a port of 44444 on the content rule and a port of 443 on the service.

Gilles.

New Member

Re: map inbound tcp port 44444 to port 443?

thank you. that worked.

203
Views
0
Helpful
2
Replies
CreatePlease login to create content