Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Microsft Netbios

In Location A, our users have a mapping drive over the WAN, the mapping will be disconnected in short period when the WAE set up in between LAN switch and WAN router. Another service - content filtering (using 8e6 R3000), it cannot be work in location A after WAE512 installed. It is using Netbios to map the R3000 on client PC, then to define the user profile.

The connectivity is

(Client PC) <-> (LAN Switch) <-> (WAE 512) <-> (WAN Router in Location A) <-> (WAN Router in Location B) <-> (WAE 612) <-> (LAN Switch) <-> (8e6 R3000) <-> (FW) <-> (Internet Router)

WAE OS version is 4.0.13

3 REPLIES
Cisco Employee

Re: Microsft Netbios

Winson,

I would add a Application Policy to bypass traffic to the IP address R3000 and then slowly add optimizations back into that policy. See if that fixes it.

Thanks,

Dan

New Member

Re: Microsft Netbios

Hi Dan,

Thanks for your prompt message.

Just clarified that the application policy settings you suggested,

1) Create Application policy,

Select Acceleration -> Policies -> Definitions

2) New Application Policy

Type: Basic

Application : Other

Application Classifier : R3000 (defined Destination address)

Action : Passthrough

Accelerate: Do Not Set

Please confirm me the above settings that is your expectation.

Thanks,

Winson

Cisco Employee

Re: Microsft Netbios

Winson,

I always put my policies under the All Device Group to maintain a global standard across all my WAEs (but it should definitely go under where you manage your global policies), so I start by the following.

Devices/Device Groups/All Device Group/Acceleration/Definitions/

There I would follow your step 2). If the R3000 starts working again, then you can incrementally add TFO, then DRE/LZ to see if it works. I might also add a Application to then track the optimizations in the CM GUI if you so desire.

Dan

123
Views
0
Helpful
3
Replies
CreatePlease to create content