Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Moved CSM's from 6509 to 6513

I just upgraded to a 6513 with sup720's. I moved both csm's and config info to the new config. Everything is working but before the move I could see both csm probe details and they were both operable. Now after the move only the active say's operable and the standby says failed. How do I get this back so that both are operable?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Moved CSM's from 6509 to 6513

you will have to do some troubleshooting.

Get on the standby.

See if it can ping the server.

'ping mod csm X x.x.x.x'

Check csm arp table.

Check L2 mac-address table between CSM and server.

finally, sniff on the server to see if it gets the probe and if it does send a response.

Once you know exactly why it fails, you'll know how to fix it.

Gilles.

2 REPLIES
Cisco Employee

Re: Moved CSM's from 6509 to 6513

you will have to do some troubleshooting.

Get on the standby.

See if it can ping the server.

'ping mod csm X x.x.x.x'

Check csm arp table.

Check L2 mac-address table between CSM and server.

finally, sniff on the server to see if it gets the probe and if it does send a response.

Once you know exactly why it fails, you'll know how to fix it.

Gilles.

New Member

Re: Moved CSM's from 6509 to 6513

Thank you. I must have over looked the config on the standby csm. The server address on the standby csm was not set. It looks good now. Thanks again.

121
Views
0
Helpful
2
Replies
CreatePlease to create content