Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multicast UDPTN

I need to input an async data stream into a serial RS232 interface and broadcast/multicast the async data to remote sites simultanously. How can I use the multicast UDPTN feature.

Please advise.

Thank you.

Regards,

HC

1 REPLY
Silver

Re: Multicast UDPTN

When configuring the Asynchronous Serial Traffic over UDP feature for multicast transmission, you must configure IP multicast routing for the entire network that will receive or propagate the multicasts. When configuring the feature for broadcast transmission, you must configure broadcast flooding on the routers between network segments. See the "Configuring IP Multicast Routing" chapter of this guide for information on how to configure IP multicast routing.

Try:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800d97d4.html#wp1001010

143
Views
0
Helpful
1
Replies