Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Multiple Bind IDs on Local Director

I have a Local Director config that is using 2 bind ids. The default Bind ID of 0 (default) is allowing a virtual IP to hit three web servers on port 80 and 443. I have the other Bind ID of 1 which sends traffic from a given class C address to web server #1 on port 80. See commands below (I changed the IPs below for security reasons):

virtual 10.10.10.10:80:1:tcp

bind 10.10.10.10:80:1:tcp web01:80:0:tcp

assign 10.10.10.10:80:1:tcp 192.168.110.0 255.255.255.0

assign 10.10.10.10:80:1:tcp 10.61.1.0 255.255.255.0

I added the following commands to allow it to connect on 443 as well:

virtual 10.10.10.10:443:1:tcp

bind 10.10.10.10:443:1:tcp web01:443:0:tcp

assign 10.10.10.10:443:1:tcp 192.168.110.0 255.255.255.0

assign 10.10.10.10:443:1:tcp 10.61.1.0 255.255.255.0

When I put these commands in, all SSL traffic stopped. Any ideas? Port 80 still worked.

1 REPLY

Re: Multiple Bind IDs on Local Director

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

214
Views
0
Helpful
1
Replies
CreatePlease to create content