If I use the probe of a serverfarm, in another serverfarm as a second probe (or logic), the probe randomly fails in the second serverfarm, but works in the first. It does not matter what kind of probes I use. I have tried http, and tcp probes. If I create a probe with different name, but identical function in the second farm, the situation is the same.It seems that it is a bug, but I did not find anything relating this in the release notes.
The main function I would like to achive is that if the number first server fail in the first farm.The number first server should be go down in the second farm.
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...
Introduction This document will run you through a step by step
configuration example of Inter VRF route leaking in Cisco Application
Centric Infrastructure(ACI). This article describes the steps with
screen shots of example configuration and some verifica...