Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multiply subnets of VIPs on CSS

I want to use more than one subnet of VIPs on a CSS11503. I cannot trunk the uplink. Is it possible to use VIPs that are not associated to a physical interface.

  • Application Networking
3 REPLIES
Cisco Employee

Re: Multiply subnets of VIPs on CSS

this is possible.

You just need a static route on the upstream router to point the subnet at the CSS.

Regards,

Gilles.

New Member

Re: Multiply subnets of VIPs on CSS

The question is, how can I configure the CSS to use VIPs that are not associated to a physical interface?

Cisco Employee

Re: Multiply subnets of VIPs on CSS

there is nothing to do.

Just configure it as if the ip was part of a physical interface.

The most important part is what I told you in my previous answer - make sure to route the traffic to the CSS.

G.

125
Views
0
Helpful
3
Replies