Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NAM VB

Hello

I have a wave 574 working like an acelerator applications in my Data Center. In the Virtual Blade 1 I installed the NAM according: http://www.cisco.com/en/US/docs/net_mgmt/network_analysis_module_virtual_blade/4.1/install/guide/vbinstall.html

The problem is that I dont get reports with Response Time (the status is No Data, the other Reports works. I tried to find other guides but could not find one.

Does anyone know that this occasioned that the reports don't work?

Best Regards,

1 REPLY
Bronze

Re: NAM VB

To generate WAAS before-and-after reports by collecting response time information from the client data source and combining it with information from the Passthru data source.

Step 1 Log in to the WAE.

Step 2 Configure the WAE to optimize the server traffic with the following commands:

config t

tfo optimize full

The purpose of this is to have the NAM VB receive optimized flows to enable post-WAAS impact analysis.

Step 3 Wait for 15-30 minutes (or longer depending on the application) for the Client report to collect data.

Step 4 On the NAM GUI, click Monitor > Response Time for the Client data source and collect the baseline server response time numbers. You can get more metrics by choosing the server and clicking Details.

http://www.cisco.com/en/US/docs/net_mgmt/network_analysis_module_virtual_blade/4.1/install/guide/beforeafter.html

128
Views
0
Helpful
1
Replies
CreatePlease to create content