Have a pair of 11503s. Cannot get a response for http requests from a server in the content vlan to another server in the same vlan via the vip. Am getting a response for requests to the Real Ip address of the server. Just not from the VIP.
All pings etc are being replied to.
Requests coming from any vlan outside the css to either the physical IP or the vrrp ip are being replied to.
this is, because your Destination Server will reply to your requesting Server directly, and Traffic will not pass the CSS. This does not work, because the Server will response with hiw onw IP Adress, not with the VIP.
There are 3 Solutions,
1) patch the Servers direcly on the CSS, so any traffic will pass the CSS
2) Put the Server in different Subnets, so that CSS is the defaultrouter for both.
3) configure a Sourcegoupe
add destination server server_A
add destination server server_B
So on methond 3, any request to the server_A and server_B will have the configured vip ip as source-ip
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...