not sure if this is the place to ask or not, if not if you can direct me to the correct place that would be great.
I have a Nexus 1000v on a esxi server. The server has two NICs that go to two different switches that are completely isolated from each other. I have a vSwitch set up that can access the vCenter, and a port from the 1000v is attached to that vSwitch - that uses NIC1.
NIC2 is attached to the 1000v in the UPLINK port-profile, and I can reach a bunch of hosts and the Vmk0 that I added to the Control Port-profile (maybe not the right place to add it - but it works)
here is the config of the 1000v
no feature telnet
username admin password 5 $1$Aet3Mefy$sm3z3sbncQg27LkcYnVBH. role network-admin
Now comes my problem, I have a NMS attached to a c3750 on NIC2 that would really like to manage the 1000v itself however I can't figure out how to get the two to talk.
I've put the same network on basically all the Vethernet port-profile vlans, but can't get to the mgmt0 interface, and can't put ip address on anyother interface. It seems like it only wants to talk on interface two in the vmware host definition ... What am i missing
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...