Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Poor user experience after WAAS Installation

Hi,

  I have got the the network setup as follows:

Branch:Users are connected to a Cisco 3750 switch with single vlan and have a single gateway router with two wan links.

            WAE appliance is connected to the same vlan with the users and the intercept/return method is WCCP gre.

Datacenter: Each of the WAN Links are connected to two separate cisco 7600 routers at the datacenter. and the servers are behind these routers.

                  The WAE appliance is connected to the two 7600s and generic gre is used for interception/return between the WAAS appliance and the

                  Cisco 7600.

After Inserting WAAS in path of the User traffic, i get all the nice compression details on the CM indicating that the WAAS workss fine but the user experience is even worse. I have also ensured that no link in the path is on Half duplex, what else could be causing a degrade of the perfrmance.

Please find attached configs template for the devices in this setup.

1 REPLY
New Member

Re: Poor user experience after WAAS Installation

Hi,

We had the same issue for one of our site, that was speed problem.

The WAE was in 100/full the 3com switch was in 100/full.

After change it to auto/auto in WAE and switch everything was ok.

Have seen this wiki?

http://docwiki.cisco.com/wiki/Cisco_WAAS_Troubleshooting_Guide_for_Release_4.1.3_and_Later

Jan

160
Views
0
Helpful
1
Replies