Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port Load Balancing

Hey folks,

Need some help with the following:

I have a class map that load balances by IP address any port/protocol...I want to NOT load balance a specific port...I think the following will do the trick, but am not positive...if anybody has any input, please provide.

class-map match-all HQ_OCS_Front_End_to_Edge_Internal_WebConf_Policy_VIP_L4

description FE to Edge Web Conf

2 match vitual-adress <IP> any

no match port tcp eq 8057

1 REPLY
Cisco Employee

Re: Port Load Balancing

unfortunately that would not work.

The 'no ...' command is only used to remove a previously configured command.

What you can do is create an access-list to block traffic sent to port 8057 and use this access-list as an access-group in on your inbound vlan interface.

Gilles.

202
Views
0
Helpful
1
Replies